Hi Andrew,
Thank you for the feedback! Your instructions work fine.
We have a port to iOS for building CA client libraries for both the simulator and devices (iphone/ipod/ipad). What is the procedure for contributing the relevant configuration files back to the EPICS community?
thanks,
tom
On Sep 15, 2010, at 4:02 PM, Andrew Johnson wrote:
> Hi Tom,
>
> On Thursday 09 September 2010 12:10:42 Pelaia II, Tom wrote:
>> I am using cross compiled targets to build CA client libraries, but I only
>> need the Com and Ca libraries. Is there a mechanism to control which
>> libraries get built for cross compiled targets without also restricting the
>> host builds?
>
> Assuming you have already built Base for the host architecture in this tree
> (typing "make darwin-x86" or similar achieves this) the simplest way would be
> make -C src libCom ca
> which will build everything in the libCom and ca directories for all cross-
> compiled targets configured for this host architecture.
>
> HTH,
>
> - Andrew
> --
> The best FOSS code is written to be read by other humans -- Harald Welte
>
- Replies:
- Re: controlling cross compiled build products Andrew Johnson
- References:
- controlling cross compiled build products Pelaia II, Tom
- Re: controlling cross compiled build products Andrew Johnson
- Navigate by Date:
- Prev:
Re: Strange gateway error message Dirk Zimoch
- Next:
Re: Stream Device With Parameters Dirk Zimoch
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: controlling cross compiled build products Andrew Johnson
- Next:
Re: controlling cross compiled build products Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|