Experimental Physics and
Industrial Control System

Ralph Lange <[email protected]> · Thu, 22 Jul 2010 14:08:38 -0400

 I would recommend running your IOC in procServ, which - among a large
number of other things - allows you to log your IOC's output into a file.
procServ is available on SourceForge - it is also part of the Debian
distribution.
Good luck!
Ralph

On 22.07.2010 13:55, Patrick Thomas wrote:

Hi,
I was wondering if there was a way to tee the output of a Linux ioc to
a file? I have tried piping to the tee command, but this causes the
output to 'freeze up' after a few seconds. Thank you for your time,
-Patrick

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System