Experimental Physics and
| |||||||||||||||
|
I have a puzzle that I'm not sure where to begin with. I've written device support for Opto22 remote I/O based on Opto22 provided libraries. I have been using it for a few years without trouble until the other day I set PINI = 1 on an output record. It turns out I haven't needed to do this before. The the record got stuck in a funny state with UDF = 1, if I subsequently write to the record the new value appears there but not in hardware. Also, these output records do a read from remote hardware during record init so I'm surprised that I should have a problem later, i.e. during initialProcess(). If PINI is not set I can write to the record and hardware without problem. Any ideas where to begin? Thanks, John Dobbins Cornell Laboratory for Accelerator-based Science and Education
| ||||||||||||||
ANJ, 02 Sep 2010 |
·
Home
·
News
·
About
·
Base
·
Modules
·
Extensions
·
Distributions
·
Download
·
· Search · EPICS V4 · IRMIS · Talk · Bugs · Documents · Links · Licensing · |