Experimental Physics and Industrial Control System

Hey All,

I'm trying to setup a SBS VIPC616 with one IP-OCTAL-232 IP-pack.  The
jumper settings on the carrier have been checked and are correct.  After
issuing ipacAddVIPC616, the module is still not found.  Here's what I see
on the IOC:

vxwrks@iocfel7 -> ipacAddVIPC616("0x0000,0x0A000000")
value = 0 = 0x0
vxwrks@iocfel7 -> ipacReport(2)
    IP Carrier  0: SBS/GreenSpring VIPC616, 4 slots
      C0 S0 : No Module
        ID = 0xfbff0080, I/O = 0xfbff0000, Mem = 0x12000000
      C0 S1 : No Module
        ID = 0xfbff0180, I/O = 0xfbff0100, Mem = 0x12800000
      C0 S2 : No Module
        ID = 0xfbff0280, I/O = 0xfbff0200, Mem = 0x13000000
      C0 S3 : No Module
        ID = 0xfbff0380, I/O = 0xfbff0300, Mem = 0x13800000
value = 0 = 0x0

I've tried this with Ipac and Asyn version already installed here at Jlab
and have setup my own using ipac-2.8 and asyn-4.11.  Any ideas on why the
module is not being initialized?

Wesley

Replies:

RE: Ipac with VIPC616 Mark Rivers

Navigate by Date:

Prev: RE: drvAsynIPServerPortConfigure Mark Rivers

Next: RE: Ipac with VIPC616 Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: drvAsynIPServerPortConfigure Mark Rivers

Next: RE: Ipac with VIPC616 Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024