Experimental Physics and
Industrial Control System

Janet Anderson wrote:
> You could try changing LIBRARY_HOST  and PROD_HOST to LIBRARY and PROD 
> in the
> catools/Makefile. This should work if your target system can build host
> PRODs i.e. VALID_BUILDS = Host Ioc.
> 

Great!

I've added these lines to catools/Makefile

LIBRARY += catools
PROD += caget camonitor cainfo caput

recompiled EPICS base and and all the needed ca* tools were available
for my target arch too!

Thank you,
Hinko



-- 
Hinko Kocevar
Technical support engineer
Instrumentation Technologies
Velika pot 22, SI-5250 Solkan - Slovenia
T:+386 5 3352600, F:+386 5 3352601
mailto: [email protected]

http://www.i-tech.si - When your users demand stability

References:

catools for cross compiled target Hinko Kocevar

Re: catools for cross compiled target Janet Anderson

Navigate by Date:

Prev: Re: subArray processing Hinko Kocevar

Next: Re: Motor Record OMSL field Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: catools for cross compiled target Janet Anderson

Next: Motor Record OMSL field Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  <2009>  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024