Experimental Physics and
Industrial Control System

"Shepherd, EL (Emma)" <[email protected]> · Fri, 13 Feb 2009 13:39:51 -0000

Hi all,

Has anybody come across a problem where autosave fails to connect to a
number of PVs when the IOC boots up, and so cannot restore their values?

When this happens I get a line like this at the top of the autosave log
file:

! 50 channel(s) not connected - or not all gets were successful

and the last however many channels (50 in this case) in the list are
commented out as follows:

#BL24I-CS-SCAN-01:SCAN:FILE.VAL Search Issued

I haven't worked out a way of reproducing this yet, but when it does
happen it seems to be the PVs listed at the end of the .req file that
fail, almost as if it has run out of time and just given up?!

We are running autosave 4-2-1 at the moment.

Thanks,

Emma

<DIV><FONT size="1" color="gray">This e-mail and any attachments may contain confidential, copyright and or privileged material, and are for the use of the intended addressee only. If you are not the intended addressee or an authorised recipient of the addressee please notify us of receipt by returning the e-mail and do not use, copy, retain, distribute or disclose the information in or attached to the e-mail.
Any opinions expressed within this e-mail are those of the individual and not necessarily of Diamond Light Source Ltd. 
Diamond Light Source Ltd. cannot guarantee that this e-mail or any attachments are free from viruses and we cannot accept liability for any damage which you may sustain as a result of software viruses which may be transmitted in or with the message.
Diamond Light Source Limited (company no. 4375679). Registered in England and Wales with its registered office at Diamond House, Harwell Science and Innovation Campus, Didcot, Oxfordshire, OX11 0DE, United Kingdom
</FONT></DIV> 
-- 
Scanned by iCritical.

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System