Experimental Physics and
Industrial Control System

Kate Feng <[email protected]> · Tue, 13 Jan 2009 14:50:43 -0500

Rarback, Harvey wrote:

	Kate et al,

Mark Rivers wrote:

Can you figure out why the transform record is causing the crash?  It is

widely used with no other problems that I know of.

You use vxWorks. We use RTEMS.

A generic record such as "dfanout" works very well for the purpose.
In fact, I do not think a custom record such as a "transform" record is
needed.

FWIW, we at SSRL use the transform record (v5.7) with RTEMS (v4.7.1) and EPICS 3.14.8.2 and do not experience any crashes.

We never had any crash in the past either until the applications becomes

complicated. Again, this is just my courtesy gesture. The system works

very

well by using the EPICS record listed in the "Record Reference Manual"
that I  do not see  this as a big issue.  It's your choice.

Kate

                                  --Harvey Rarback