Experimental Physics and
Industrial Control System

Hi all,

 

Has anyone else run into problems with the example app in EPICS Base 3.14.10 with Sequencer 2.0.12 when running on Cygwin (ARCH=cygwin-x86)?

 

When I build the example application with the SNCSEQ in the RELEASE file commented out, the IOC builds fine and my trusty old EPICS console starts up with no problem.  When I rebuild the application with SNCSEQ=/epics/seq in the RELEASE file, it builds fine but when I run the IOC it goes immediately back to the bash command prompt, no errors, no EPICS console.

 

It’s been a couple of years since I last built an EPICS app so I’m a bit rusty at this stuff… if anyone can give me a hand it would be greatly appreciated.

 

Best regards,

 

Steve Banks