Experimental Physics and
Industrial Control System

On 9/25/08 3:06 PM, David Dudley wrote:
> What I was hoping for was a way to tell what channels connected, in
> order to determine what ones didn't make a connection.

Hi, David.

At the IOC shell, you can use seqChanShow with "-" as the second
argument to show disconnected channels.  See chapter 4, Using the Run
Time Sequencer, of the seq manual (version 2.0.11).

Lewis

Replies:

Re: SEQ tools David Dudley

References:

SEQ tools David Dudley

Navigate by Date:

Prev: SEQ tools David Dudley

Next: Re: SEQ tools David Dudley

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <2008>  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: SEQ tools David Dudley

Next: Re: SEQ tools David Dudley

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  <2008>  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024