Experimental Physics and
Industrial Control System

"师昊礼" <[email protected]> · Tue, 25 Dec 2007 11:15:26 +0800

Hi,

   now I'm trying to build snl program, I use epics base 3.14.6, and seq
2.0.11, Makefile is as follows:
************************
ifneq ($(SNCSEQ),)
    # This builds sncExample as a component of power_supply
    #power_supply_DBD += sncExample.dbd
    #power_supply_SRCS += sncExample.stt
    #power_supply_LIBS += seq pv

    # The following builds cIOC1PScontrol as a standalone application
    PROD_HOST += cIOC1PScontrol
    cIOC1PScontrol_SNCFLAGS += +m
    cIOC1PScontrol_SRCS += cIOC1PScontrol.st
    cIOC1PScontrol_LIBS += seq pv
    cIOC1PScontrol_LIBS += $(EPICS_BASE_HOST_LIBS)

endif
************************

but after make, I got an error information: *** No rule to make target
`cIOC1PScontrol.o', needed by `cIOC1PScontrol'.  Stop.

thanks a lot, and Merry Christmas!

Haoli Shi

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System