I am using epics modules for MODBUS-TCP i.e. modbusIP.tar.gz developed by Bob Dalesio for communicating with Schneider PLCs. I have written a small sequencer program, but I could not run this sequencer from st.cmd. It shows the following error:
....
Starting iocInit
############################################################################
### EPICS IOC CORE built on Nov 28 2006
### EPICS R3.14.8.2 $R3-14-8-2$ $2006/01/06 15:55:13$
############################################################################
Starting Modbus Ethernet Driver: version 0.1
iocInit: All initialization complete
## Start auto operation sequence program
seq autoSequence, "user=add"
st.cmd -- Line 41 -- Command seq not found.
epics>
It seems that it could not found seq. Kindly help mw to solve this problem.
Regards
Anindya Roy
Scientific Officer
Variable Energy Cyclotron Centre, DAE
Govt. of India
1/AF, Bidhannagar, Kolkata 700 064
Contact No. 2337-1230, Extn 2304
- Replies:
- RE: Running sequencer within IOC Mark Rivers
- Navigate by Date:
- Prev:
What is epicstcl Emmanuel Mayssat
- Next:
RE: Running sequencer within IOC Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: What is epicstcl Eric Berryman
- Next:
RE: Running sequencer within IOC Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|