Hello,
When you instantiate a thread in the sequencer, you can use program
macros (logfile, debug, etc) to configure the seqLog (and more)
function.
The issue is that once the seq is started, you cannot change the values
of the macros in iocsh. At least this is what I believed.
As once again, I went through the seq documentation, I stumbled on the
macValueGet function, which apparently would imply that it is possible
to change macro values on the fly.
If that is the case, how can I change the seq macros in iocsh?
(the idea is to increase/decrease debug level when the seq is RUNNING)
Also what are the user debug level allowed by the seq?
Does seqLog accept debug levels?
Apparently not... but I could always create my log function.
Regards,
--
Emmanuel Mayssat
- Navigate by Date:
- Prev:
Re: error code mapping best practice Rodney R. Porter
- Next:
Job Opennings at NSLS II bdalesio1
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: error code mapping best practice Maren Purves
- Next:
Job Opennings at NSLS II bdalesio1
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|