Experimental Physics and
Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 <2007> 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	Firewire (IEEE1394) Camera driver - errors in st.cmd file
From:	"Margaret Smith" <[email protected]>
To:	<[email protected]>
Date:	Thu, 19 Apr 2007 16:13:56 -0600

Anyone understand these error msgs. I've got the Firewire camera driver and medm screen provided by SLS (from webpage http://epics.web.psi.ch/software/firewire/) running, but I get some error messages in the st.cmd file as follows:

st.cmd -- Line 18 -- Command save_restoreSet_Debug not found.
st.cmd -- Line 19 -- Command set_requestfile_path not found.
st.cmd -- Line 20 -- Command set_savefile_path not found.
st.cmd -- Line 21 -- Command save_restoreSet_status_prefix not found.
st.cmd -- Line 22 -- Command set_pass0_restoreFile not found.
st.cmd -- Line 23 -- Command set_pass1_restoreFile not found.
st.cmd -- Line 29 -- Command create_monitor_set not found.

I've also attached the entire st.cmd file and the output when I run (st.cmd.out1).

I've got an inkling of what they, but don't know where they are. I could just remove these but may miss a feature that I want.

Thx,

Margaret

----------------------

Margaret Smith

Systems Analyst

Canadian Light Source

Phone (306) 657-3580

Fax (306) 657-3535

E-mail [email protected]

Attachment: st.cmd.out1
Description: st.cmd.out1