Ralph,
That configuration
> EPICS 3.14.8.2 / motor 6.1
> HW: vxWorks 5.4.2, mv2100, OMS VME58
is working fine for me.
Can you send your st.cmd and output?
Mark
> -----Original Message-----
> From: Ralph Lange [mailto:[email protected]]
> Sent: Friday, April 13, 2007 8:14 AM
> To: EPICS Tech Talk
> Subject: Motor Record - OMS58 Driver
>
> Hi -
>
> I'm moving a stepper motor application using an OMS VME58 card:
> from EPICS 3.13.9 / motor 4.9.3 to EPICS 3.14.8.2 / motor 6.1
>
> In the old setup everything works fine, in the new setup the driver
> claims that it doesn't find the VME58 motor card. Hardware
> settings are
> unchanged, the setup call in the st.cmd is the same.
>
> Searching the release notes of the motor record I did not
> find anything
> that I found applicable to my problem.
>
> Before I dig into the code: Is there anything obvious that I
> didn't see?
> Similar effects somewhere?
> HW: vxWorks 5.4.2, mv2100, OMS VME58, test stand with no
> other VME cards.
>
> Thanks a lot!
> Ralph
>
>
- References:
- Motor Record - OMS58 Driver Ralph Lange
- Navigate by Date:
- Prev:
Motor Record - OMS58 Driver Ralph Lange
- Next:
Re: Motor Record - OMS58 Driver Martin L. Smith
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Motor Record - OMS58 Driver Ralph Lange
- Next:
Re: Motor Record - OMS58 Driver Martin L. Smith
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|