EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: Re: Matlab interfaces
From: Till Straumann <[email protected]>
To: Mark Rivers <[email protected]>
Cc: "Allison, Stephanie" <[email protected]>, Korhonen Timo <[email protected]>, [email protected]
Date: Wed, 12 Jul 2006 14:18:04 -0700
Mark Rivers wrote:

Till wrote:



IMO it could be worthwile to develop a clean CA interface for packages
like matlab/scilab/octave from scratch - with emphasis on a 'properly
layered' approach so that different packages can easily be supported.



I agree. We use EZCA a lot from IDL and from Visual Basic. I do see the problems with reconnects on IOC reboot. If this has been fixed in the labCA version

I believe to have fixed it in labca_2_1. It passed elementary
testing.

-- T.

then it would be really nice to get those fixes back
into the version of EZCA that is in EPICS extensions.

Mark




Replies:
Waveform record help Erik Johansson
References:
RE: Matlab interfaces Mark Rivers

Navigate by Date:
Prev: RE: Matlab interfaces Mark Rivers
Next: Re: Sequencer embedded C code question Dirk Zimoch
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: RE: Matlab interfaces Mark Rivers
Next: Waveform record help Erik Johansson
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024