Experimental Physics and Industrial Control System
This is not directly an EPICS issue, but I am hoping someone in the
EPICS community can help me (or knows someone who can help).
At DLS, we are looking for status display monitors to be placed around
the site. In the past these would have been video fed, but I believe all
we have placed at the status display points are Cat6 network sockets,
and we are looking at economical ways of generating status displays.
I have looked at the panel PC's available, but they seem quite expensive
and I suspect that a small embedded PC + a monitor may be cheaper. The
system must boot linux without a disk, be an x86 architecture and have a
graphics card and Ethernet socket.
If anyone has any experience with this and has any suggestions, or can
propose any alternative architectures that might work, please contact me
with ideas off-line.
Cheers,
Nick Rees
Principal Software Engineer Phone: +44 (0)1235-778430
Diamond Light Source Fax: +44 (0)1235-446713
- Replies:
- Re: Status display monitors Mohan Ramanathan
- Navigate by Date:
- Prev:
Re: Matlab interfaces J. Frederick Bartlett
- Next:
Re: Status display monitors Mohan Ramanathan
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Thales Optem 30-17-70 Leicester, PJ (Pete)
- Next:
Re: Status display monitors Mohan Ramanathan
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024