EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: binary serial interface
From: "D. Peter Siddons" <[email protected]>
To: [email protected]
Date: Thu, 22 Jun 2006 15:03:48 -0400
Hi all,
I need to interface a USB motor controller which has a protocol which consists of sequences of binary (i.e. non-ASCII) byte string commands and responses. No end-of-string character is used, but the length of the response is coded in one of the first six response bytes. Some events (limit switches, e.g.) cause responses which are not a direct response to a command. What is the best tool to use for such a beast?
Thanks,
Pete.

Replies:
RE: binary serial interface Mark Rivers
RE: binary serial interface Mark Rivers

Navigate by Date:
Prev: ASYN based support for Digitel SPC (Small Pump Controller) John Dobbins
Next: RE: binary serial interface Mark Rivers
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: ASYN based support for Digitel SPC (Small Pump Controller) John Dobbins
Next: RE: binary serial interface Mark Rivers
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <20062007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024