Antonino Miceli wrote:
Hi,
I am running EPICS R3.14.7 on a MVME2700.
I am configuring Canberra's AIM MCA modules. Having issues with
the TCA module.
icbConfig seems to be fine:
icbConfig("icbTca1", 0x98c, 1, 1)
value = 0 = 0x0
dbLoadRecords("$(MCA)/mcaApp/Db/icb_tca.db",
"P=dp3:,TCA=tca1,MCA=aim_adc1,PORT=icbTca1")
value = 0 = 0x0
But I get the following errors:
2006/04/28 11:11:17.728 drvIcbAsyn::drvUserCreate, unknown command=HI1
dp3:tca1SCA1_HI devAsynFloat64::initCommon drvUserCreate
2006/04/28 11:11:17.728 drvIcbAsyn::drvUserCreate, unknown command=LOW1
dp3:tca1SCA1_LOW devAsynFloat64::initCommon drvUserCreate
2006/04/28 11:11:17.728 drvIcbAsyn::drvUserCreate, unknown command=HI2
dp3:tca1SCA2_HI devAsynFloat64::initCommon drvUserCreate
etc...
Any hints on what this might be?
icbConfig("icbTca1", 0x98c, 1, 1)
says you're configuring an amplifier module, not a TCA module. Try
icbConfig("icbTca1", 0x98c, 1, 3)
Here are the ICB module-type numbers:
0 adc
1 amp
2 hvps
3 tca
4 dsp
--
Tim Mooney ([email protected]) (630)252-5417
Beamline Controls & Data Acquisition Group
Advanced Photon Source, Argonne National Lab.
- References:
- asyn and Canberra TCA 2016 Antonino Miceli
- Navigate by Date:
- Prev:
RE: asyn and Canberra TCA 2016 Mark Rivers
- Next:
Who can help with dbLoadRecords()? Liyu, Andrei
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
asyn and Canberra TCA 2016 Antonino Miceli
- Next:
RE: asyn and Canberra TCA 2016 Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|