Experimental Physics and Industrial Control System
Title: Message
Hi,
Im trying to use the
same home (HVEL) and normal velocity (VELO) setting on a motion
controller. I am attempting to set HVEL. Documentation says that
VBAS<=HVEL<=VMAX. I can set VBAS ok in my database, but VMAX
will not set. Also, no matter what value I put into HVEL, I always end up
with a HVEL=VBAS.
All my issues are at
DB initialization. If i use Dbputs after initialization, the HVEL and VMAX
fields set properly.
Ive also noted that
if VBAS=VELO then the acceleration commands in device support are never
called. Therefore I cannot set VBAS=VELO=HVEL in my database for
initialization. I dont have a base velocity on this motion
controller.
My solution thus far
is to make VBAS, and HVEL slightly different from VELO.
Would appreciate any
advice.
Thanks very
much,
Dr. Mark Clift.
Beamlines Control Systems
Engineer
Australian Synchrotron
Project
Major Projects of Victoria
800 Blackburn Road
Clayton VIC 3168
Tel: +613 8540 4264
Fax: +613 8540 4200
- Navigate by Date:
- Prev:
Old hardware Craig Walther
- Next:
NewFocus 8752 Maximilien J. Collon
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Old hardware Craig Walther
- Next:
NewFocus 8752 Maximilien J. Collon
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024