Experimental Physics and
Industrial Control System

Marty Kraimer <[email protected]> · Fri, 10 Mar 2006 06:01:38 -0500

LYNCH, Damien wrote:
Hi,
I am using EPICS 3.14.5 and asynDriver 3-1 (on Linux). How do I have
my port driver implement asynGpib? I am seeing the following warning
when I start up my IOC.
"2006/03/10 09:32:26.992 test:srqHappened parm 8 gpibCmd.type requires
asynGpib but it is not implemented by port driver".
Thanks,
Damien
First I agree with Mark's comment about trying to upgrade to a later
verson of asyn.
I suspect that you are implementing a devGpib module and have specified
one of the following commands:
GPIBACMD|GPIBREADW|GPIBEFASTIW|GPIBIFC
       |GPIBREN|GPIBDCL|GPIBLLO|GPIBSDC|GPIBGTL|GPIBSRQHANDLER
But you have connected to a port driver that is not a gpib controller.
Perhaps just a serial port driver?
Marty

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System