Experimental Physics and
Industrial Control System

I presume this change has to be made in the "devSupportGpib.c" file of the
asyn driver in the function "writeIt"? Will a make of the ASYN module be
sufficient or must I run the makeSupport command a second time (this may be
a stupid question but I'm pretty new to EPICS/ASYN etc...)

-----Oorspronkelijk bericht-----
Van: Marty Kraimer [mailto:[email protected]]
Verzonden: dinsdag 29 november 2005 14:27
Aan: '[email protected]'
Onderwerp: Re: ASYN command string with null character


Bruins, Stefan wrote:

>For the building of device support through the ASYN driver I have to sent a
>message with a null character inside. The problem is that the driver
>terminates the string at this null character according to the C++ standard.
>My question is, how am I able to overcome this problem?
>
>Stefan Bruins
>  
>

You have to call  pasynOctet->writeRaw instead of pasynOctet->write.

Marty Kraimer

Replies:

Re: ASYN command string with null character Marty Kraimer

Re: ASYN command string with null character Eric Norum

Navigate by Date:

Prev: Re: ASYN command string with null character Marty Kraimer

Next: Re: ASYN command string with null character Marty Kraimer

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: ASYN command string with null character Marty Kraimer

Next: Re: ASYN command string with null character Marty Kraimer

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024