Experimental Physics and
Industrial Control System

"Liyu, Andrei" <[email protected]> · Wed, 13 Jul 2005 11:53:56 -0400

Hi,

1. When I use errlogMessage first time then

- I see on terminal

hebt-diag-ioc-blm1>errlogMessage("First+N\n")
First+N
value = 0 = 0x0
hebt-diag-ioc-blm1>log client: lost contact with log server at
"172.31.72.101:6500" because "S_errno_EPIPE"
log client: connected to error message log server at
"172.31.72.101:6500"

- I don't see anything in errorLog file!

2. Then I type again
hebt-diag-ioc-blm1>errlogMessage("Second+N\n")
Second+N
value = 0 = 0x0
I see response from errorLog file
hebt-diag-ioc-blm1.ics.sns.gov: Wed Jul 13 11:38:02 2005 Second+N

One more time but without "\n"
hebt-diag-ioc-blm1>errlogMessage("Third")
Thirdvalue = 0 = 0x0
I see response from errorLog file
hebt-diag-ioc-blm1.ics.sns.gov: Wed Jul 13 11:38:32 2005 Thirdd+N

I suppose this is not ioc that errlog server! If I reboot IOC I see the
same tail from buffer.

3. If I don't use errlogMessage with "\n" all time I see very strange.
At first, I don't see error message from item 1. At second, I see
response from errorLog file each time when buffer is full (~1280).

4. Of course, I don't refuse to see a little smart client for text file.
Where I can choice message by ioc name, system/subsystem/module name and
so on. And maybe it will work from buffer ... :-)

Have a good day, Andrei Liyu

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System