Experimental Physics and
Industrial Control System

Eric Norum <[email protected]> · Mon, 13 Jun 2005 08:43:14 -0500

On Jun 13, 2005, at 7:57 AM, Dalesio, Leo `Bob` wrote:
This was an estimate I was given to do an RTEMS BSP for the motorola
6600.

Does anyone else have any experience/estimates for this type of work?

Bob

As would be expected, the time required to produce an RTEMS BSP depends
upon the existence of a BSP for similar processors/devices. For
example, I was able to modify the ColdFire MCF5272 BSP to work on an
MCF5282 in a couple of weeks. I was starting from a good existing base
and I had a pretty good idea of the hardware's operation. I would
think that a four month development would be reasonable for a
board/architecture for which there was no similar BSP and for which you
had no prior experience.
--
Eric Norum <[email protected]>
Advanced Photon Source
Argonne National Laboratory
(630) 252-4793

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System