Experimental Physics and
Industrial Control System

Hi All,

I'm trying to record the start time and end time of a small application of 
mine on timing system. Hardware: EVG-110, IOC MVME5100. Software: Solaris 
8, EPICS base 3.13.8, egRecord, erRecord, egeventRecord, ereventRecord, 
timestampRecord. The interval between the start time and end time should 
be less than 20 milli seconds. But I found that the start time and end 
time recorded are always the same, around the booting time of the IOC. The 
command 'date' on IOC gives the same time always, too. With this IOC, if I 
download other applications without the event system library, the command 
'date' works correctly.
 
So is there something that I may miss setting up? Could anybody give me 
some suggestions? 

Thank you very much,

Ge

Replies:

Re: result of date command on IOC of EVG Korhonen Timo

Navigate by Date:

Prev: Re: Flavors of Linux D. Peter Siddons

Next: Building EPICS base 최현미

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: Data Access Class Library Tutorial Liyu, Andrei

Next: Re: result of date command on IOC of EVG Korhonen Timo

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024