Experimental Physics and
Industrial Control System

Andrew Johnson <[email protected]> · Thu, 16 Dec 2004 15:25:09 -0600

I have just produced a new release of drvIpac, version 2.8 requires
vxWorks and EPICS Base 3.14.3 or later. The main changes are:
 * Added a carrier driver for the Tews TVME200 carrier board (a.k.a. the
SBS VIPC626)

* Fixed the problem with port 7 of a tyGSOctal module hanging up when
run from an MVME5100 CPU board

* Improved robustness against faulty hardware or configuration
parameters by providing a routine ipacLatestCarrier(), and always
incrementing the carrier number even if a carrier initialization fails

* A new irqCmd ipac_slotReset is available for carrier boards that are
capable of resetting an individual IP slot, i.e. the TVME200 only.
Available from the usual place:
	http://www.aps.anl.gov/asd/people/anj/ipac/
- Andrew
--
Dear God, I didn't think orange went with purple until I saw
the sunset you made last night.  That was really cool. - Caro

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System