If you want to compile base for vxWorks target systems, you will have to
change the VX_DIR entry in ...base.../configure/RELEASE to point to your
vxWorks installation.
(This is also mentioned in the file ...base.../documentation/README.1st
under "Software Requirements / Tornado 2".)
Hope this helps,
Ralph
>>>>> "xuguanglei" == xuguanglei <[email protected]> writes:
> hello,all
> after i follow the steps of documentation
> i got the error like this
> gmake[3]: /usr/local/vw/tornado202p1/host/x86-linux/bin/ccppc£ºcommon not
> find
> gmake[3]: *** [bucketLib.o] error 127
> gmake[3]: Leaving directory
> `/usr/local/epics/base-3.14.6/src/libCom/O.vxWorks-ppc604'
> gmake[2]: *** [install.vxWorks-ppc604] error 2
> gmake[2]: Leaving directory `/usr/local/epics/base-3.14.6/src/libCom'
> gmake[1]: *** [libCom.install] error 2
> gmake[1]: Leaving directory `/usr/local/epics/base-3.14.6/src'
> gmake: *** [src.install] error 2
> does this means i must install cross-gcc-2.9.6.tar.gz?
- References:
- install base 3.14.6 in linux-x86 error xuguanglei
- Navigate by Date:
- Prev:
install base 3.14.6 in linux-x86 error xuguanglei
- Next:
Segmentation fault for CA client(EPICS 3.14.6) Song, Jinhu
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
install base 3.14.6 in linux-x86 error xuguanglei
- Next:
Segmentation fault for CA client(EPICS 3.14.6) Song, Jinhu
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
<2004>
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
| 
·
Home
·
News
·
About
·
Base
·
Modules
·
Extensions
·
Distributions
·
Download
·