EPICS Controls Argonne National Laboratory

Experimental Physics and
Industrial Control System

1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  <20042005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  <20042005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: MVME-5100 choices
From: Steven Hartman <[email protected]>
To: EPICS tech-talk <[email protected]>
Date: Fri, 25 Jun 2004 13:29:01 -0400 (EDT)
I am about to order some MVME-5100 single board computers. I notice that
there are two different processors available for this family: the
MVME5100-016x with a 450 MHz MPC750, and the MVME5110-2x6x with a 400 or
500 MHz MPC7410.

Are either of these processors acceptable (tested) with EPICS on VxWorks?
Any strong recommendations of one over the other?

I will be using Tornado-2.2.1/VxWorks-5.5, with EPICS R.3.13.10 initially,
but perhaps a 3.14 version later.

Thank you,
-- 
Steve Hartman
[email protected] || 919-660-2650
Duke Free Electron Laser Laboratory

Navigate by Date:
Prev: Re: caSnooper output report question Andrew Johnson
Next: Next EPICS Meeting - Response Needed Bob Dalesio
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  <20042005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: Re: caSnooper output report question Andrew Johnson
Next: RE: MVME-5100 choices Thompson, David H.
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  <20042005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
ANJ, 10 Aug 2010 Valid HTML 4.01! · Home · News · About · Base · Modules · Extensions · Distributions · Download ·
· Search · EPICS V4 · IRMIS · Talk · Bugs · Documents · Links · Licensing ·