EPICS can't pvput sub record by caTCL

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	can't pvput sub record by caTCL
From:	"黄松" <[email protected]>
To:	"[email protected]" <[email protected]>
Date:	Thu, 20 May 2004 9:25:44 +0800

Hi, 

I can't use "pv put" of caTCL for subRoutine record. For example, if I have a subRoutine record
named "sub", then under et_wish, I run the following commands,

bepc huangson> et_wish
% pv linkw aaa "sub.A"
0
% set aaa 5
5
% pv putw aaa
1
% set errorCode
ca_sg_block:timeout

So I can't put value to the sub record under et_wish. And I can use caput to do this,

bepc huangson> caput "sub.A" 5
Old : sub.A          0
New : sub.A          5

Are there some solutions for this?

　　　　　　　　[email protected]
　　　　　　　　　　2004-05-20

Navigate by Date:: Prev: Re: next 3.14 release Andrew Johnson; Next: EPICS collaboration meeting presentations - Update Pilar Marroquin; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
Navigate by Thread:: Prev: Re: next 3.14 release Andrew Johnson; Next: EPICS collaboration meeting presentations - Update Pilar Marroquin; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 <2004> 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024