Experimental Physics and
Industrial Control System

Geoff Savage <[email protected]> · Tue, 18 May 2004 11:06:09 -0500

Thank you for the reminder about reading the release notes. I was able
to build my extensions by setting COMPAT_TOOLS_313=YES.
Thanks to everyone for the assistance.
Geoff
Ralph Lange wrote:
Note that there's also a second variable called
 COMPAT_313
that can be set to YES to allow 3.13 IOC applications to be built.
Btw: All of this is explicitly covered in the 3.14.5 Release Notes, but
I know that such information always has a strong tendency to be in the
one place that you don't look for it.
Cheers,
Ralph

"Andy" == Andy Foster <[email protected]> writes:

 > Geoff,
 > I had a problem with "makeMakefile.pl" not being copied to
 > the bin directory.
 > It turned out to be because I hadn't set:
 > COMPAT_TOOLS_313=YES
 > in
 > "base/configure/CONFIG_SITE"
 > This is a change introduced in the configuration files
 > between releases 3.14.4 and 3.14.5.
 > Not sure whether this will solve all of your problems
 > but hope it helps anyway.
 > Cheers,
 > Andy

 > On Fri, 14 May 2004, Geoff Savage wrote:
 >> Hi,

>>
>> As the subject says I am attempting to build R3.13 extensions with

>> R3.14.5. I am following the instructions at

>> http://www.aps.anl.gov/epics/modules/base/R3-14/5-docs/BuildingR3.13ExtensionsWithR3.14.html

>> with no success. Here are the error messages.

>>
>> [savage@d0ol30 extensions]$ gmake

>> stat(): No such file or directory at ./config/fullPathName.pl line 6

>> stat(): No such file or directory at ./config/fullPathName.pl line 6
 >> [...]

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System