Hello -
We use two device/driver support packages here at SSRL that require
the functionality of epicsMutexLockWithTimeout which is no longer supported
in 3.14.1. In ipac, it's only needed by the canRead diagnostic routine so I simply
used the same logic I found in epics base/src/db/dbLock.c which does a little
loop with try/wait. But in ether_ip, this functionality is a key part of the support.
There was discussion about this in core-talk and a few sentences in the 3.14.1
release notes, but it's not clear the best way to port from epicsMutexLockWithTimeout
(or vxWorks semTake with a non-WAIT_FOREVER timeout) to something
equivalent.
Any suggestions? Thank you,
Stephanie Allison
SSRL/SLAC
- Replies:
- RE: epicsMutexLockWithTimeout not supported in 3.14.1 Jeff Hill
- Navigate by Date:
- Prev:
drvAscii R3.14 version Porter, Rodney R.
- Next:
Re: epicsMutexLockWithTimeout not supported in 3.14.1 Kay-Uwe Kasemir
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
<2003>
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: drvAscii R3.14 version Kevin Tsubota
- Next:
RE: epicsMutexLockWithTimeout not supported in 3.14.1 Jeff Hill
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
<2003>
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|