EPICS OMS 58 and auxiliary outputs

Experimental Physics and Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	OMS 58 and auxiliary outputs
From:	Rok Sabjan <[email protected]>
To:	[email protected]
Date:	Wed, 15 Jan 2003 09:39:54 +0100

Hello!

I'm dealing with some stepper motor control and would like to use auxiliary outputs of the OMS 58 motor controller card for setting the stepper driver to all windings off mode. Has this been attempted before? I have looked into motor record, but was unable to find any implementation of that functionality.

Do you think this is possible?

br

Rok

Replies:: Re: OMS 58 and auxiliary outputs David Maden; Re: OMS 58 and auxiliary outputs Martin L. Smith

Navigate by Date:: Prev: Re: Where is caput? Ralph Lange; Next: Re: EPICS Setup/Installation Ralph Lange; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024
Navigate by Thread:: Prev: [no subject] psichta; Next: Re: OMS 58 and auxiliary outputs David Maden; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 <2003> 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024