g+
g+ Communities
Argonne National Laboratory

Experimental Physics and
Industrial Control System

1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014 
<== Date ==> <== Thread ==>

Subject: OMS 58 and auxiliary outputs
From: Rok Sabjan <rok.sabjan@cosylab.com>
To: tech-talk@aps.anl.gov
Date: Wed, 15 Jan 2003 09:39:54 +0100
Hello!

I'm dealing with some stepper motor control and would like to use auxiliary outputs of the OMS 58 motor controller card for setting the stepper driver to all windings off mode. Has this been attempted before? I have looked into motor record, but was unable to find any implementation of that functionality.

Do you think this is possible?

br

Rok


Replies:
Re: OMS 58 and auxiliary outputs David Maden
Re: OMS 58 and auxiliary outputs Martin L. Smith

Navigate by Date:
Prev: Re: Where is caput? Ralph Lange
Next: Re: EPICS Setup/Installation Ralph Lange
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014 
Navigate by Thread:
Prev: [no subject] psichta
Next: Re: OMS 58 and auxiliary outputs David Maden
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  <20032004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014 
ANJ, 10 Aug 2010 Valid HTML 4.01! · Home · News · About · Base · Modules · Extensions · Distributions · Download ·
· EPICSv4 · IRMIS · Talk · Bugs · Documents · Links · Licensing ·