Hi,
I'm using:
@(#)SNC/SEQ Version 1.9.2.Beta12 : Mon Jan 10 11:45:25 2000
with EPICS 3.13.2 under vxWorks on an mvme167.
In attempt to set the task priority, I'm invoking the
following:
seq &dpCorr, "priority=86, U=DP"
I can't seem to make this work;i.e, the task priority
always turns out to be 100 no matter what I set "priority="
to.
iocts1fb> i
.
.
dpCorr _sequencer a0b410 100 PEND+T ......
.
.
What am I doing wrong?
I know I can use taskPrioritySet() to set the priority after
the fact, but I thought the "priority=" parameter would
be simpler.
Tnx
Frank
--
------
Frank Lenkszus [email protected] (630) 252-6972
Advanced Photon Source -- Controls -- Argonne National Laboratory
- Replies:
- Re: Sequencer priority parameter Benjamin Franksen
- Navigate by Date:
- Prev:
Re: Capturing a telnet connection event Andrew Johnson
- Next:
Re: Sequencer priority parameter Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
<2002>
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Capturing a telnet connection event Ned Arnold
- Next:
Re: Sequencer priority parameter Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
<2002>
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|