Hi all,
I have problems with VIPC616 IP carrier board. I have some IP module
developed for the home made field bus. This IP module uses only
I/O registers, no memory. When I work via mv162 IP carrier it works
OK. But when I tried to use VIPC616 I failed. I use all default
settings for VIPC616 (base address 0x6000, memory is disabled).
This IP has 16 bit control registers.
I see that mapping is OK. When I sent a command to IP I see that
LED for the proper slot is blinking, e.i. I address right registers.
On the field bus side I see also LED blinking. This means that some
information reaches the bus. But this information is not correct.
The information on field bus side consist of all "1"s, although
I send there some packed bus address, which doesn't consist of all "1"s.
What could be the cause of information distortion?
I appreciate any help, thanks in advance,
V.Korobov
e-mail: [email protected]
- Replies:
- Re: Problems with VIPC616 IP carrier board Andrew Johnson
- Navigate by Date:
- Prev:
comments in display manager files john sinclair
- Next:
Re: Problems with VIPC616 IP carrier board Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
comments in display manager files john sinclair
- Next:
Re: Problems with VIPC616 IP carrier board Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|