Nick> Does anyone have a good set of routines for turning off line mode in a
Nick> standard Unix terminal driver (i.e. turning on the equivalent of the
Nick> VxWorks OPT_RAW mode). My problem with the tnetDrv code was that I
Nick> couldn't get the psuedo terminal to go into character mode. I looked
Nick> through all the ioctl codes on Solaris and couldn't find anything that
Nick> looked right, but on the other hand most of the standard communication
Nick> packages use character mode and so it obviously can be done - I just
Nick> couldn't find the codes. The answer must be bleeding obvious, but since I
Nick> have never done this sort of thing before, I got stuck.
Aloha, Nick,
Dig in TFM under section termio(7) and look at "Non-Canonical Mode Input
Processing". With MIN=0 and TIME=0 input is non-blocking, character mode
input like RAW mode used to be. These are in the c_cc array in the termios
structure set by the TCSETA ioctl .
Jim
- References:
- Re: tnet driver Nick Rees
- Navigate by Date:
- Prev:
Re: tnet driver Allan Honey
- Next:
MATLAB Song, Jinhu
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: tnet driver Nick Rees
- Next:
Re: tnet driver Allan Honey
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|