Experimental Physics and
Industrial Control System

Burkhard-

On Fri, 12 Nov 1999, Burkhard Kolb wrote:

> Problem: I have an MVME162 with a CANbus interface which controls
> several Wiener fantrays. When increasing the number of crates I
> suddenly get errors during dbloadrecords. The records are all
> generated by the same templates, so I know they are correct.

Are you getting a "workQPanic"?  I ran into that problem with an almost
identical setup.  Make sure that your CANbus chain is properly terminated.
Also, make sure that all parameters (especially baud rate) are correctly 
set on each Wiener crate.  Hope that helps.

						-Dennis

References:

database limits Burkhard Kolb

Navigate by Date:

Prev: Re: database limits Ralph . Lange

Next: Re: EPICS and IDL Ben-chin K. Cha

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: database limits Burkhard Kolb

Next: Re: database limits Ned Arnold

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024