Experimental Physics and
Industrial Control System

Detlef <[email protected]> · Mon, 4 Oct 1999 08:31:29 +0200

On 1.10.1999 at 8:55, [email protected] (Leonard J. Reder)
wrote:

> Hello all,
> 
> I am interested if anyone in the EPICS community is utilizing a
> current technology frame grabber board with EPICS/VxWorks.  The
> board must be either PMC, that is a PCI doughter card which
> plugs into, in our case, the VME Motorola MVME2307 PPC SBC.  Or
> it can also be a stand alone frame grabber which connects
> directly to a VME bus.
> .........
> .........
> Thanks in advance,
> 
> Leonard J. Reder
> Keck Interferometry Project
> 
> -- 
> ____________________________________________________
> Leonard J. Reder
> Jet Propulsion Laboratory
> Interferometry Systems and Technology Section 383
> Email: [email protected]
> Phone (Voice): 818-354-3639
> ____________________________________________________

Hi Leonard,
  we are using a PMC modules from DataCell (http://www.datacell.co.uk)
in a Motorola mv2306 board. The grabber is a 24bit multiplexed ( 4fold)
triggerable unit which can also be operated in monochrome mode. Epics
support has been written by Miroslaw Dach ( [email protected] ).
Contact him for the details.

regards, Detlef Vermeulen

--------------------------------------------------------------------------
        Detlef Vermeulen           phone: +41 56 310 3620 
        Paul Scherrer Institute    fax:   +41 56 310 4413 
        SLS Computing & Controls   mailto:[email protected] 
--------------------------------------------------------------------------

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System