Experimental Physics and
Industrial Control System

Hi,

Does anybody knows if there is an ADC in the EPICS supported hardware
list which is capable to measure the peak voltage of a transient signal
occuring during a gate ? 

This is a typical Data acquisition application that I was able to make
with old CAMAC modules.

I understand that this is probably a very marginal application for
EPICS, but who knows...

  Dominique

--
Dominique Boutigny                 (E-mail: [email protected])

Laboratoire d'Annecy-le-Vieux de Physique des Particules (L.A.P.P.)
Chemin de Bellevue   BP 110  F-74941 Annecy le Vieux CEDEX - France

Now at SLAC - PO Box 4349 - Mail Stop 41 - 94309 Stanford CA - USA

Tel@ SLAC: 650 926 3596           Pager : (650) 849 9218
Fax@ SLAC: 650 926 8522           [email protected]

Navigate by Date:

Prev: Re: Calling all Power PC EPICS sites Benjamin Franksen

Next: RE: Need an EPICS supported "peak sensing" ADC Mark Rivers

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Build problems Dave Reid

Next: RE: Need an EPICS supported "peak sensing" ADC Mark Rivers

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024