Subject: |
Re: VMIC VMIVME-3230 Thermocouple board |
From: |
Graham Waters <[email protected]> |
Date: |
Wed, 05 May 1999 11:29:33 -0700 |
Chris Tierney wrote:
>
> Hi tech-talk,
>
> I need to use EPICS for control of a VMIVME-3230
> (Intelligent 8-channel thermocouple board for VME bus)
> built by VMIC, but it's not on the list of supported
> hardware. Does anyone have experience of controlling this
> board with EPICS?
>
Hi
I have EPICS drivers for some VMIC cards and in my experience
they all have a fairly similar register address map.
The closest device I have is the 3801 adc, it could be a starting point.
My drivers are available via anonymous ftp at sunset.triumf.ca pub/epics
+---------------------------------------------------------------------+
|Graham Waters, Control System Eng Internet: [email protected]|
|TRIUMF --- University of British Columbia, phone: (604)-222-1047 |
|Vancouver, BC, Canada Fax: (604)-222-7307 |
|http://edevel9pc.triumf.ca/homepage/graham01.html |
+---------------------------------------------------------------------+
For every expert there is an equal and opposite expert
- Arthur C Clark
- Navigate by Date:
- Prev:
VMIC VMIVME-3230 Thermocouple board Chris Tierney
- Next:
re: 3282759 byte messages Michael J. Feldhake
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
VMIC VMIVME-3230 Thermocouple board Chris Tierney
- Next:
re: 3282759 byte messages Michael J. Feldhake
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|