Subject: |
problems with OMS motor controller and power pc cpu board mv2306 |
From: |
Werner Portmann <[email protected]> |
To: |
[email protected] |
Date: |
Wed, 07 Apr 1999 09:41:59 +0200 |
Hallo everybody
I try to run an OMS motor controller with a mv2306 power pc cpu board
and I don't
succeed. During initialization I get the error message that _excStub and
_excIntStub are not in the symbol table.
With the mv167 board these two symbols are defined in vxWorks.
In the case of the mv2306 these two symbols (and perhaps others, too)
are not defined in vxWorks.
Because of the different architecture there might be other functions.
But, how are they called?
Has somebody modified a driver for the mv2306 board?
Has somebody experience with interrupt handling on a mv2306 board?
Thanks for any help
Werner
--
Dr. Werner Portmann, SLS computing and controls, Paul Scherrer Institut
CH-5232 Villigen PSI
tel + 41- 56 3104061 fax + 41 - 56 310 4413
e-mail: [email protected]
- Navigate by Date:
- Prev:
Re: Looking for EPICS edd 1.16 built for Solaris Everett Harvey
- Next:
Re: problems with OMS motor controller and power pc cpu board mv2306 William Lupton
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Looking for EPICS edd 1.16 built for Solaris Everett Harvey
- Next:
Re: problems with OMS motor controller and power pc cpu board mv2306 William Lupton
- Index:
1994
1995
1996
1997
1998
<1999>
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|