Experimental Physics and
Industrial Control System

[email protected] (Kevin Tsubota) · Fri, 5 Feb 1999 14:42:54 -1000

I've just started playing with a MVME2307 PowerPC vme board
and EPICS R3.13.0Beta12.  

When loading iocCore I get the following:

ld < epics/base/bin/mv2304/iocCore
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.
Relocation value does not fit in 24 bits.

I just read in the vxWorks manual that PowerPC architecture
limits its relative addressing to 24-bit offsets to conform to
Embedded Application Binary Interface (EABI).

What did I do wrong?

Thank you.

Kevin Tsubota

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System