A question for motor record gurus.
I have been using the motor record for some time and have encountered a
wee problem with stopping a stepper motor after the HOMF or HOMR field
has been set. I am assuming that HOMF/HOMR will be reset when the home
switch is encountered so am I right in thinking that the STOP signal
will be effectively ignored during the home seek operation unless
HOMF/HOMR is reset? The documentation on the Web;
at http://www.aps.anl.gov/xfd/SoftDist/swBCDA/recMotor.html
does not say if HOMF/HOMR is reset immediately or when the home switch
is found.
==============================================================================
Len Lawrence Tel. : +44 (0)131 668 8255 (direct)
UK Astronomical Technology Centre
Royal Observatory +44 (0)131 668 8100 (switchboard)
Blackford Hill [email protected]
Edinburgh EH9 3HJ aka [email protected]
- Replies:
- Re: motor record query Benjamin Franksen
- Navigate by Date:
- Prev:
Modular Circuit Technology software Dayle Kotturi
- Next:
Re: motor record query Benjamin Franksen
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Modular Circuit Technology software Dayle Kotturi
- Next:
Re: motor record query Benjamin Franksen
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|