Subject: |
Modular Circuit Technology software |
From: |
Dayle Kotturi <[email protected]> |
To: |
EPICS interest group <[email protected]> |
Date: |
Thu, 8 Oct 1998 19:52:42 -0700 (MST) |
Hi tech-talkers,
I installed the MCT software on a Windows NT PC hoping to burn
some EPROMs (Manufacturer=AMD, Device=AM27C4096). After I
select the manufacturer and device, the window goes black and
reports: "Error identification on hardware". I followed the
tech-tip to switch the jumper settings from the default (2E0)
to other possibilities (trying 200, 210, 220, ...) but for all
these, the same message appeared.
Has anyone used this software successfully on Windows NT?
Any advice is appreciated,
Dayle
***********************************************************************
Dayle Kotturi
Software Engineer Phone: 808-974-2558
Gemini North Observatory Fax: 808-935-9235
Street Address: 670 N. A'ohoku Place, Hilo, HI 96720
Mailing Address: P.O. Box 485, Hilo, HI 96721
***********************************************************************
- Navigate by Date:
- Prev:
Wavetex 395 Jan Chrin
- Next:
motor record query Len Lawrence
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Wavetex 395 Jan Chrin
- Next:
motor record query Len Lawrence
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|