Experimental Physics and
Industrial Control System

[email protected] (Bob Dalesio) · Wed, 26 Aug 98 15:40:18 MDT

It seems to me that there are two possible approaches to looking
at the Industry Pac interfaces.
1) That each Carrier Board is the driver 
	Therefore a list of devices on the carrier board is kept
	Driver reports are done from the carrier board perspective
2) Each different IP module board is the driver
	A seperate report,init exists for each IP module supported
	Carrier boards have no driver - but address mapping and interrupt handling routines

I am interested to hear how this was handled in the different drivers.
All polite comments welcome.
	Bob

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System