Experimental Physics and
Industrial Control System

On Fri, 14 Aug 1998, Ralph Lange wrote:

> 
> The only problem could be Raw Soft Support, as there is no address
> information in the INP/OUT fields and SHFT will always be 0. Right?
> 

But if SHFT were allowed to be set by GDCT, wouldn't it just be
overwritten by the device support layer in the cases where the device
support sets this field, thus making it work for all cases?

Cheers,

Andy

===================================================================================
Andy Foster
Gemini 8-m Telescopes Project	Tel:     1 (808) 974 2556 (direct)
Gemini-North Base Facility      Fax:     1 (808) 974 9235
670 North A'ohoku Place
University Park			E-mail:  [email protected] or
Hilo                                     [email protected]
Hawaii 96720
USA

Replies:

Re: MBBI, SHFT, and GDCT Ralph Lange

References:

Re: MBBI, SHFT, and GDCT Ralph Lange

Navigate by Date:

Prev: increasing scan rates Geoff Savage

Next: RE: increasing scan rates Jeff Hill

Index: 1994  1995  1996  1997  <1998>  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: MBBI, SHFT, and GDCT Ralph Lange

Next: Re: MBBI, SHFT, and GDCT Ralph Lange

Index: 1994  1995  1996  1997  <1998>  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024