Experimental Physics and
Industrial Control System

Ian Ferguson <[email protected]> · Fri, 7 Aug 1998 15:58:19 -0700 (PDT)

I'm trying to write a simple driver that executes a block transfer to a
homemade card, but I have found very little information on the subject.  I
noticed that the Allen Bradley card uses this transfer method, but there
is much more there than I need.  Could someone point me to a simple source
code which uses block transfers?  It doesn't even have to be wrapped in
the EPICS structure, just the function calls would be helpful.  Thanks for
any advice. 

VxWorks version 5.2
KERNEL: WIND version 2.4
MVME167-32B
EPICS Version R3.12.2

Ian Ferguson
[email protected]

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System