Experimental Physics and
Industrial Control System

I am trying to get an IOC to bootup using w/ rsh instead of ftp.  When I
make the switch I get the following messages (followed by the vxWorks
Logo) and some other messages.  Can anyone determine from this why the
IOC loads using ftp and not rsh?


Attaching network interface ei0... done.

Attaching network interface lo0... done.

Loading... 437992 + 50684 + 27258

Starting at 0x1000...



Attaching network interface ei0... done.

Attaching network interface lo0... done.

Loading symbol table from apis:epicsApps/bin/mv167/vxWorks.sym
...apis:stty: : I
nvalid argument

Error opening apis:epicsApps/bin/mv167/vxWorks.sym: status = 0x290010



Thanks,
John
------------------------------------------------------------------------
----
John P. Hammonds
Intense Pulsed Neutron Source
Argonne National Laboratory
(630)252-5317

Replies:

Re: Problem booting ioc w/ rsh instead of ftp Ralph Lange

Re: Problem booting ioc w/ rsh instead of ftp Andrew Johnson

Navigate by Date:

Prev: Re: CNAF control commands using a CES "CBD 8210 branch driver" Graham Waters

Next: Re: Problem booting ioc w/ rsh instead of ftp Ralph Lange

Index: 1994  1995  1996  1997  <1998>  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: CNAF control commands using a CES "CBD 8210 branch driver" Graham Waters

Next: Re: Problem booting ioc w/ rsh instead of ftp Ralph Lange

Index: 1994  1995  1996  1997  <1998>  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024