Experimental Physics and
Industrial Control System

mauro <[email protected]> · Tue, 10 Feb 1998 12:25:52 +0000

Dear All,

I'm using EPICS R3.13.0.beta11, MV162, VxWorks 5.2 and
GPIB-1014 (Gpib-VME by National Instruments).

I'm testing a gpib device. The rules are two :

1) I must use only EOI true for message termination;
2) All data sent to, or read from, the device must be in 
     binary, not in ASCII characters.

Now I have a sequence of numbers to execute a device command :
30 0 17 0 0 128
For this test I'm using GPIBInteract, then write:
\x1e\x0\x11\x0\x0\x80
but the device don't execute the command (only busy led
turn on for a second).

Where is my mistake ?

Thanks in advance
Mauro.

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System