EPICS Controls Argonne National Laboratory

Experimental Physics and
Industrial Control System

1994  1995  1996  1997  <19981999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  <19981999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: mv167 Parity
From: Marty Kraimer <[email protected]>
To: [email protected]
Date: Thu, 15 Jan 1998 11:09:04 -0600
While investigating an ioc problem we (actually Frank Lenkszus) noticed
that the mv167 board support package does not enable parity checking.

Has anyone enable parity checking on the mv167?
What changes to the board support package are necessary?
Are there any problem doing this?

We looked at both vxWorks 5.2 and vxWorks 5.3 board support. Neither
enables parity.

Marty Kraimer

Replies:
Re: mv167 Parity Dave Reid

Navigate by Date:
Prev: job offer ECKART%MPEIA4
Next: Re: mv167 Parity Dave Reid
Index: 1994  1995  1996  1997  <19981999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: job offer ECKART%MPEIA4
Next: Re: mv167 Parity Dave Reid
Index: 1994  1995  1996  1997  <19981999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 
ANJ, 10 Aug 2010 Valid HTML 4.01! · Home · News · About · Base · Modules · Extensions · Distributions · Download ·
· Search · EPICS V4 · IRMIS · Talk · Bugs · Documents · Links · Licensing ·