Hello all,
I tried to become familiar with data base debugging and
set a breakpoint with the dbb "..." command from the IOC console. This
was obviously accepted with a return code of 0. Then trying to
single-step by just typing dbs sent the IOC into hyperspace (at
least the console was dead) and I had to reboot. What am I doing
wrong? What should I see?
I am running R3.12.2.patch6 on a MV162-43.
+----------------------------------------------------------+
: Rolf Keitel | [email protected] :
: TRIUMF | Tel: (604) 222-7453 :
: 4004 Wesbrook Mall | Fax: (604) 222-7307 :
: Vancouver, B.C., V6T 2A3 | www.triumf.ca :
+----------------------------------------------------------+
- Navigate by Date:
- Prev:
Farewell to all John R. Winans
- Next:
A tool to support development of GP-IB device support routine. Noboru Yamamoto
- Index:
1994
1995
<1996>
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Farewell to all John R. Winans
- Next:
A tool to support development of GP-IB device support routine. Noboru Yamamoto
- Index:
1994
1995
<1996>
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|